Cuboid Spacer System

H & M’s  Cuboid Spacer System relieves frustration and downtime in looking  for lost spacers, because the spacers never leave the machine.

The H & M Cuboid is a six-sided form with rectangular sides.   Three specific thicknesses  conform to different pipe sizes.  Only four cuboid spacers are used to quickly set up the machine. In the past 12 spacers were required.

The saddle of each H & M machine and the four cuboid allow four specific pipe sizes to be cut.  Each side of every cuboid is clearly stamped to ensure the corrict pipe size.   When not in use the cuboid spacers are securely housed on the back of the saddle.  It’s a no-lose proposition in time-saving productivity!

Saddle Design

H & M achieves  function and financial advantages for the customer over its competition by designing the precision saddle and ring gear as separate components.

Instead of locating the ring gear in the middle H & M places the saddle behind the ring gear, greatly reducing the risk of warping the saddle while back-beveling.

H & M’s Saddle Assembly is less likely to be damaged; however, if a problem occurs,  this seperate component design is more econimical in replacement costs.

7CS Solid Torch Holder

Now standard on all H & M Saddle-Type Beveling Machines, the Adjustable Torch Holder, the Out-of-Round Attachment and all shape cutting attachments, the Solid Torch Holder provides greater cutting accuracy, efficiency and strength. A single thumbscrew secures the torch instead of hose clamps. A cotter pin makes the thumbscrew  captive to the torch holder, allowing easy removal or replacement of the torch. Precise and simple to use, the Solid Torch Holder means solid performance.

NOTE: The Solid Torch Holder is available  for retrofitting to H & M’s Torch Carrier Assembly.  Only two screws are needed for removal and replacement.

2DH Boomer Strap Eye Assembly

Forget cotter pins and S-hooks.  H & M offfers a safer, more dependable Boomer Strap Eye on Models 1 and 2 Standard Pipe Beveling Machines. It allows the chain on the boomer assembly to quickly adjust and securely lock the machine to its respective pipe size. The boomer assembly is now a captive member of the machine.

Quality Control

Every  H & M machine is manufactured through  a rigid system of quality controls, calibrated to ± .025 in concentricity and ± .015 in squareness during final assembly and then re-checked one last time before distribution.